Table of Contents
Advertisement
5. Connect the Base Wire (52) to the Upright Wire
(75). See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER.
Then, remove the tie (A) from the Base Wire
(52), and insert the connectors into the holes (B)
in the right Upright (83) and the Base (74).
6. Identify the right handrail assembly (C). Hold
the right handrail assembly near the right side of
the console assembly (D), and connect the two
pulse wires (E).
Next, set the right handrail assembly (C) on the
console assembly (D). Make sure that no wires
are pinched.
Attach the right handrail assembly (C) with a
3/8" x 5 1/2" Screw (1) and a 3/8" x 3 3/4" Screw
(2); start both Screws, and then tighten them.
Attach the left handrail assembly (not shown)
in the same way.
5
83
A
74
6
C
11
B
75
52
B
75
52
D
E
2
1
Advertisement
Table of Contents
