Table of Contents
Advertisement
4.12.7
Testing ARC reporting
The Test – ARC Reporting option is available if the control unit uses a 4G- or PSTN-module to communicate
alarms to an Alarms Receiving Centre (ARC). Master and admin users can use Test – ARC Reporting to test the
connection to the ARC.
To carry out the test:
1. Select Test – ARC Reporting.
The following is displayed:
ARC REPORTING
Recipient A <Tel 1>
2. Use
or
to choose one of the two recipients selected by the installer. Each recipient uses
▲
▼
a separate telephone number to the ARC. Depending on how the installer has configured
communications, the second line may be used if the first fails to connect.
3. Press 4 to start the test.
Test call started...
The keypad shows the progress of the call. Check with the ARC that the test call arrived. If the call
fails, the display shows "Call failed", followed by the reason.
4.13 System configuration
The System Config menu allows you to change some parts of the system to suit your particular needs.
4.13.1 Switching facilities on/off
System Config – Facilities On/Off can be used to switch the following facilities on or off:
Chime
Use this option to enable or disable the chimes that occur when a zone is triggered that has a
Chime attribute (as set up by the installer). For most zone types, a chime occurs only when the
system is unset.
Remote Access
Use this option to enable or disable remote access to the control unit from the web interface or
ABUS Cloud.
Note: By default, this feature is off for security reasons. Make sure that any installer requesting
access is your authorised installer. Switch off remote access once the installer has finished.
Level 4 Update
Use this option to enable or disable access to the control unit from the level-4 user. There can be
only one level-4 user, which only the installer can create.
Using the system
25
Advertisement
Table of Contents
