Table of Contents
Advertisement
2. EITHER:
a. Press the button on the remote control you want to re-program. Hold down the button until you
see the transmit LED flash.
OR (if you do not have the remote control):
a. Press 4 at the "Press Remote Button" prompt.
b. Use
or
followed by 4 to select the remote control you want to re-program.
▲
▼
c. The display lists the first button on the remote control:
RM002:User 002
Button *
The top line of the display shows the identity of the remote control, the button you pressed or
selected, and the name of the owner. For example:
RM002,*:User 002
*Part Set
3. Use
or
followed by 4 to choose the function for the button.
▲
▼
Note: The unset button can only be used to unset some or all partitions allocated to the user. See
Unset, Unset All and Unset, Partitions below.
No Action
For the button to have no action.
Part Set
To part set B/C/D. This applies only to the partition assigned to the remote control. Use
followed by 4 to select the part set.
Output
To operate a user-defined output. Use
followed by 4 to select the output mode:
▼
• On – Switches the output on.
• Off – Switches the output off.
• Toggle – Changes the state of the output each time you press the button.
4. Press ✘ repeatedly to exit.
Deleting remote Controls
You may want to delete a remote control if is lost or you want to reassign it to another user. You must
delete a remote control before you can reassign it to another user.
The System Config – Remotes menu provides two options for deleting remote controls:
Delete
This allows you to delete a specific remote control (see below).
32
or
followed by 4 to select the output, then use
▲
▼
or
▲
▼
or
▲
Using the system
Advertisement
Table of Contents
