Table of Contents
Advertisement
Switch Binary Report
Shows the status of the piezo siren alarm.
0x00
0xFF
Siren On/Off
Switches the status of the piezo alarm of the siren
0xFF
0x00
3.2.
Overview configuration parameters
Z-Wave products can be used directly after inclusion in the network. Configuration settings, however,
can be used to adapt the device's behavior even better to the requirements of the application and to
activate additional functions.
para-
byte
meter
size
1
2
2
2
3.3. Overview of Supported Command Classes
1. COMMAND_CLASS_ZWAVEPLUS_INFO_V2
2. COMMAND_CLASS_ASSOCIATION_V2
3. COMMAND_CLASS_ASSOCIATION_GRP_INFO
4. COMMAND_CLASS_TRANSPORT_SERVICE_V2
5. COMMAND_CLASS_VERSION_V3
6. COMMAND_CLASS_MANUFACTURER_SPECIFIC_V2
7. COMMAND_CLASS_DEVICE_RESET_LOCALLY
8. COMMAND_CLASS_POWERLEVEL
9. COMMAND_CLASS_SECURITY
10. COMMAND_CLASS_SECURITY_2
11. COMMAND_CLASS_SUPERVISION
12. COMMAND_CLASS_FIRMWARE_UPDATE_MD_V2
13. COMMAND_CLASS_BATTERY
14. COMMAND_CLASS_NOTIFICATION_V4
15. COMMAND_CLASS_SWITCH_BINARY
16. COMMAND_CLASS_CONFIGURATION
17. COMMAND_CLASS_SENSOR_MULTILEVEL
18. COMMAND_CLASS_SOUND_SWITCH
3.4. Wake Up Time (Wake Up Time)
The Z-Wave indoor siren is a FLiRS (Frequently Listening Receiver Slave) and therefore does not
require a wake up function. The indoor siren can be controlled by the Z-Wave Gateway at any time.
value
value
default
range
value
10-600
180 sec
1-1440
30 min
Description of the
Siren's off.
Siren's on.
Description of the
Siren is activated and LED starts flashing
Siren is deactivated and LED goes out
Description of the
Piezo Sirens Alarm duration
Temperature and humidity Transmission interval
15
English
Advertisement
Table of Contents
