Abus Secoris ESEZ60500 User Manual page 31

Note: If a user activates the output while it is deactivated, the output stays activated until the
control unit reaches the next off time. If a user de-activates the output while it is activated, the
output deactivates until the control unit reaches the next on time. Leave On Time, Off Time and Days
without values if you want the output to act as a simple on/off switch.
4. Press 4 when you have finished editing On Time/Off Time/Days.
4.13.6 Managing remote controls
You can use System Config – Remotes to specify the functions that can be carried out using remote controls.
The System Config – Remotes menu contains the following options:
Edit
Used to edit the programming of the buttons, such as the buttons used to set or unset the system,
or operate outputs.
Delete
Deletes a selected remote control.
Delete All
Deletes all remote controls.
Unset
Enables or disables the ability for all remote controls to unset the system.
HUA Function
Enables or disables the ability for remote controls to generate Hold-Up Alarms (HUAs).
These options are described next.
Editing the programming of the buttons
You can use System Config – Remotes – Edit to re-program the "*" button after the devices have been
assigned to a user.
The button can be programmed to:
• Set a selected part set (only the partition the remote control is assigned to).
• Operate an output configured as "User Defined" by the installer.
To re-program the button on a remote control:
1. Select System Config – Remotes – Edit.
The following is displayed:
EDIT REMOTE
Press Remote button
Using the system
31