Sas Enable; Software Raid Enable - Supermicro X7DCL-3 User Manual

SAS Enable/Disable
JPA1 allows you to enable or disable
SAS Connectors. The default position is
on pins 1 and 2 to enable SAS. See the
table on the right for jumper settings.
(Note: This feature is available on the
X7DCL-3 only.)

Software RAID Enable

JPA2 allows you to select the SAS RAID
mode. You can use either Software
RAID or IT RAID. Close this jumper to
use Software RAID (Default). Set this
jumper to open to use the IT RAID mode.
Contact Tech. Support at Supermicro for
more information. See the table on the
right for jumper settings.
(Note: This feature is available on the
X7DCL-3 only.)
JPWF1
JAR
24-Pin PWR
8-Pin PWR
DIMM2A
DIMM1A
DIMM2B
DIMM1B
DIMM2C
DIMM1C
X7DCL-3/i
JPL2
LAN
CTRL
Intel 5100
North Bridge
I-Button
LAN
CTRL
Slot6 PCI-E x8
SP1
Buzzer
Slot5 PCI-E x8
Slot4 PCI-E x4(in x8 slot)
VGA
CTRL
JPG1
Slot3 PCI 33MHz
Slot2 PCI 33MHz
S I/O
JWD1
JWOL1
Slot1 PCI 33MHz
System Status LED
COM2
SIMLC
Jumper Settings
Close (Default)
Open (Note)
(Note: Also contact tech support at Super Micro for
further instructions.)
CPU1 VRM OH LED
SMB_PS
CPU1
CPU2
LED6
CPU2 VRM OH LED
JP2
JP1
Intel
ICH9R
PWR LED
LED3
South Bridge A
JBT1
LED1
BIOS
Battery
LSI
SAS
CTRL
ITE
SAS-GPIO1
CTRL
SAS-GPIO0
B
JPA2
LED4
USB4/5
USB2/3
JL1
2
BPI C
2-27
Chapter 2: Installation
SAS Enable/Disable
Jumper Settings
Jumper Settings Defi nition
Pins 1-2 Enabled (Default)
Pins 2-3 Disabled
Software RAID
Jumper Settings
Defi nition
Software RAID Enabled
IT Mode Enabled
A. SAS Enabled
LED5
B. Software RAID Enable
Fan 2
Fan 3
Fan 4