Quick Reference - Supermicro X7DCL-3 User Manual

Quick Reference (X7DCL-3/X7DCL-i)
Jumper Description
JBT1 CMOS Clear
2 2
JI C1/JI C2 SMB to PCI/PCI-Exp Slots
JPG1 VGA Enable
JPA1 (Note) SAS Enable
JPA2 (Note) Software RAID/IT RAID Mode
JPL1/ JPL2 GLAN1/GLAN2 Enable
JWD Watch Dog
Connector
BPI 2 C
COM1/COM2
FAN 1-6
Floppy
FP Control
IDE
J7/J8/9/10
JAR1
JD1
JIBTN1
JL1
JPW1
JPW2
JPWF1
JUSB1/JUSB2/3
JWOL
JWOR
Keylock
LAN1/2
2
PWR I C
SAS0-SAS7 (Note)
SATA0-SATA5
SIMLC
VGA
LED Indicator
LED1
LED3/LED4
LED5/LED6
Note: SAS is available on the X7DCL-3 only.
Description
Back Panel Power System Management (I
COM1/COM2 Serial Port and Header
Fans 1-2: CPU Fans, Fans 3-6: System cooling fans
Floppy Disk Drive Connector (JFDD1)
Front Control Panel Connector (JF1)
IDE Hard Drive
Serial-Links General Purpose Input/Output Headers
(J7/J8: SATA T-SGPIO 0/1, J9/J10: SAS T-SGPIO 0/1)
Alarm Reset Header
Power LED(pins1-3)/SpeakerHeader (pins 4-7)
I-Button Socket
Chassis Intrusion Header
+12V 8-pin PWR
Primary 24-Pin ATX PWR Connector
Power Supply Failure (See Chapter 2)
BP USB0/1 (JUSB1), FP USB2/3/4/5 (JUSB2/3)
Wake-on-LAN Header
Wake-on-Ring Header
Keylock Header (JKEY1)
G-bit Ethernet Ports 1/2
Power System Management (I
Serial Attached SCSI Connectors (#0-#7) (X7DCL-3)
SATA 0-5 Connectors
IPMI SIMLC Slot (JIPMI)
VGA Port
Description
SAS LED
Power LED (LED3)/System Status LED (LED4)
CPU1/CPU2 VRM Overheat (respectively)
1-5
Chapter 1: Introduction
Default Setting
See Chapter 2
Open (Disabled)
Pins 1-2 (Enabled)
Pins 1-2 (Enabled)
Closed (Software RAID)
Pins 1-2 (Enabled)
Pins 1-2 (Reset)
2 C) Header
2 2
C) Header (JPI C1)