Attach The Optical Network Cable - Cisco Nexus 9804 NX-OS Hardware Installation Manual

Attach the Optical Network Cable

Figure 29: Installing the QSFP Transceiver Module
Step 6 Press firmly on the front of the transceiver module with your thumb to fully seat the transceiver in the module's transceiver
socket (see the below figure).
Caution If the latch isn't fully engaged, you might accidentally disconnect the transceiver module.
Figure 30: Seating the QSFP Transceiver Module
Attach the Optical Network Cable
Before you begin
Before you remove the dust plugs and make any optical connections, follow these guidelines:
• Keep the protective dust plugs installed in the unplugged fiber-optic cable connectors and in the transceiver
• Inspect and clean the optical connector end faces just before you make any connections.
Cisco Nexus 9804 NX-OS Mode Switch Hardware Installation Guide
42
optical bores until you are ready to make a connection.
Connect Switch to the Network