Adding Pci Cards - Supermicro SUPERSERVER 6015V-MR User Manual

S
UPERSERVER 6015V-MR/6015V-MRLP User's Manual
Notch
Release
Tab
To Install: Insert module vertically and press down until it snaps into place. Pay attention
to the bottom notch.
To Remove: Use your thumbs to gently push each release tab outward to free the DIMM
from the slot.
5-6

Adding PCI Cards

1. PCI slots
The 6015V-MR/6015V-MRLP includes a CSE-RR1U-X riser card. This riser fi ts
into a 133/100MHz PCI slot to support a full-height, half-length PCI expansion
card.
2. PCI card installation
Before installing a PCI add-on card, see step 1, above. Begin by swinging out the
release tab on the appropriate PCI slot shield. Insert the PCI card into the riser
card, pushing down with your thumbs evenly on both sides of the card. Finish by
pushing the release tab back to its original (locked) position.
Figure 5-5a. Installing DIMM into Slot
Note: Notch
should align
with its
receptive point
on the slot
Figure 5-5b. Top View of DDR2 Slot
5-8
Notch
Release
Tab