Table of Contents
Advertisement
Figure 52. Installing the optional optical drive
Next steps
1
Install the front bezel.
2
Follow the procedure listed in the
Processor and heat sink
Removing the heat sink
Prerequisites
WARNING:
The heat sink may be hot to touch for some time after the system is powered down. Allow the heat sink to cool
before removing it.
1
Follow the safety guidelines listed in the
2
Follow the procedure listed in the
3
Remove the air
shroud.
4
Remove the expansion card
Steps
1
Using a Philips #2 screwdriver, loosen the screws on the heat sink in the order mentioned below:
a
Loosen the first screw three turns.
b Loosen the screw diagonally opposite to the screw you loosened first.
c
Return to the first screw and loosen it completely.
d Repeat the procedure for the remaining two screws.
2
Lift the heat sink away from the system.
After working inside your
Safety
instructions.
Before working inside your
riser.
system.
system.
Installing and removing system components
81
Advertisement
Table of Contents
