Advertisement
Quick Links
Product Installation Guidelines
®
GalvinAssist
Centre T 700x1100 SS Hygienic Grab Rail
PRODUCT CODES:
-
41978CP (Chrome Hose & Handpiece)
-
41978 (White Hose & Handpiece)
SPECIFICATIONS
The GalvinAssist
®
range of Stainless Steel grab rails provides safe and reliable fixtures for
WC's and accessible areas in health institutions, hospitals and detention facilities.
All the items can comply with clause 17 of AS 1428.1-2009 if positioned correctly according to
the standard.
IMPORTANT: All Galvin Engineering taps are tested in accordance with AS/NZS 3662 and
leave our premises in good working order.
WARNING: Special attention to be paid on notes, photos, images, or drawings of assembly
steps marked with the warning symbol.
TECHNICAL DATA
Inlet
Outlet
Headwork
Working Pressure Range (kPa)
Working Temperature Range (°C)
Nominal Flow Rate (LPM)
Finish
The shower may not be suitable for use in gravity-fed water heaters, low pressure supply networks,
instantaneous water heaters, tempering valves and thermostatic mixing valves. (AS3662-2013).
For use with potable water only. Not suitable for low or unequal pressure water supply.
NOTE: Galvin Engineering continually strive to improve their products. Specifications may change
without notice.
TOOLS REQUIRED
Power drill
Spanner or adjustable crescent
© Galvin Engineering Pty Ltd
Hand Shower with Inverted
th
Version 1, 4
Version 1, 4 September 2023, Page 1 of 5
41978CP
41978
½" BSP – Female
Handheld Shower
N/A
Min
150
Max
500
Min
5
Max
55
41978CP
8.24
41978
5.62
N/A
September 2023, Page 1 of 5
Document No.: 001.00.40.02
Advertisement
Related Manuals for Galvin Engineering Assist 41978CP
Summary of Contents for Galvin Engineering Assist 41978CP
- Page 1 All the items can comply with clause 17 of AS 1428.1-2009 if positioned correctly according to the standard. IMPORTANT: All Galvin Engineering taps are tested in accordance with AS/NZS 3662 and leave our premises in good working order. WARNING: Special attention to be paid on notes, photos, images, or drawings of assembly steps marked with the warning symbol.
- Page 2 Product Installation Guidelines Version 1, 4 September 2023, Page 2 of 5 Version 1, 4 September 2023, Page 2 of 5 PRE- INSTALLATION MOUNTING DETAILS © Galvin Engineering Pty Ltd...
-
Page 3: Installation
Version 1, 4 September 2023, Page 3 of 5 INSTALLATION INSTALLATION COMPLIANCE: Galvin Engineering products must be installed in accordance with these installation instructions and in accordance with AS/NZS 3500, the PCA and your local regulatory requirements. Water and/or electrical supply conditions must also comply to the applicable national and/or state standards. - Page 4 Fit elbow over spigot and secure with grub Connect hose and shower head ensuring screw. the connection is secured, then turn on water Using 2.5mm hex key supplied, tighten 5mm supply. Check for any leaks. grub screw. © Galvin Engineering Pty Ltd...
-
Page 5: Troubleshooting
The warranty set forth herein is given expressly and is the only warranty given by the Galvin Engineering Pty Ltd. With respect to the product, Galvin Engineering Pty Ltd makes no other warranties, express or implied. Galvin Engineering Pty. Ltd. hereby specifically disclaims all other warranties, express or implied, including but not limited to the implied warranties of merchantability and fitness for a particular purpose.