Problems Related To Copy Results - Sharp MX-B401 Operation Manual

Problem
Two-sided copying
does not take place.
The paper size of a
tray cannot be set.

PROBLEMS RELATED TO COPY RESULTS

Problem
The image is too light
or too dark.
Part of the image is
cut off.
Copies come out
blank.
Point to check
Does the paper type setting of the
selected tray specify a type of paper that
cannot be used for two-sided copying?
Are you using a special size or type of
paper?
Are you copying using settings that do
not allow two-sided copying?
Have functions been disabled by the
administrator?
Have functions been disabled by the
administrator?
Point to check
Is the image too light or too dark?
If you selected an original type instead
of "Auto" for the copy exposure setting,
is the selected original type appropriate
for your original?
Has an appropriate ratio been selected
for the original size and paper size?
Are you using an AB size original?
Has the correct original size been set?
Is the original placed face up or face
down correctly?
Check "Tray Settings" in the system settings. If the
[Disable Duplex] checkbox is selected
copying using that tray will not be possible. Change the
paper type setting to a type that can be used for
two-sided printing.
➞ System Settings > "Paper Tray Settings" > "Tray
Settings" > "Change"
For the paper types and sizes that can be used for
two-sided copying, see "SPECIFICATIONS" in the
Maintenance & Safety Guide.
Two-sided copying can generally be combined with
other special modes, however, some combinations are
not possible. If a prohibited combination is selected, a
message will appear in the touch panel.
Some functions may have been disabled in the system
settings (administrator). Check with your administrator.
When user authentication is enabled, the functions that
you can use may be restricted in your user settings.
Check with your administrator.
Some functions may have been disabled in the system
settings (administrator). Check with your administrator.
Select an appropriate exposure mode for the original
being copied and adjust the exposure level manually.
Select the original type that matches your original. If the
wrong type is selected, suitable image adjustment will
not be possible.
Select an appropriate ratio setting.
When copying an AB size original, specify the original
size manually.
Touch the [Original] key and select the correct size.
When using the document glass, the original must be
placed face down. When using the automatic document
feeder, the original must be placed face up.
8-9
TROUBLESHOOTING
Solution
, two-sided
Solution
Contents