Table of Contents
Advertisement
to the motorcycle's on-board
10
electrical system.
226
NOTICE
The motorcycle's on-board elec-
tronics know when the battery
is fully charged. The on-board
socket is switched off when this
happens.
Comply with the operating in-
structions of the charger.
NOTICE
z
If you are unable to charge the
battery through the on-board
socket, you may be using a char-
ger that is not compatible with
your motorcycle's electronics. In
this case, directly charge the bat-
tery at the terminals of the bat-
tery that has been disconnected
from the vehicle.
Charging a disconnected
battery
Charge the battery using a
suitable charger.
Comply with the operating in-
structions of the charger.
After charging, disconnect the
charger's terminal clips from
the battery terminals.
NOTICE
The battery has to be recharged
at regular intervals in the course
of a lengthy period of disuse.
See the instructions for caring
for your battery. Always fully re-
charge the battery before restor-
ing it to use.
Removing battery
Removing seat (
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
https://www.motorcycle-manual.com/
with anti-theft alarm (DWA)
If applicable, switch off the anti-
theft alarm.
Switch off the ignition.
ATTENTION
Battery not disconnected in
accordance with correct pro-
cedure
Risk of short-circuit
124).
Always proceed in compliance
with the specified disconnec-
tion sequence.
OE
Advertisement
Table of Contents
