Door Lock; Changes After Programme Has Started; Child Lock - Grundig GWN 37430 User Manual

Door lock

There is a locking system on the
loading door of the machine that
prevents opening of the door in cases
when the water level is unsuitable.
"Door Locked" LED in the panel
turns on when the loading door is
locked.
Changes after programme
has started
Adding laundry after the programme
has started:
Stopping the machine (pause)
Press the Start/Pause button to
switch the machine to pause mode
while a programme is running.
The Start/Pause and the light for
the step which the machine is in
start flashing in the programme
follow-up indicator to show that the
machine has been switched to the
pause mode. Also, the loading door
light flashes until it is possible to
open the door. Loading Door light
shall be turned off once the loading
door is ready to be opened, but the
programme step light and Start/
Pause light continue to flash.
Also, when the loading door is ready
to be opened, Loading Door light
will also turn off in addition to the
programme step light.
Changing the auxiliary function,
speed and temperature
Depending on the step the
programme has reached, you can
cancel or activate the auxiliary
functions; see, "Auxiliary function
selection".
You may also change the speed and
temperature settings; see, "Spin
speed selection" and "Temperature
selection".
C
If no change is allowed, the
relevant light will flash for
3 times.
74
Adding or taking out laundry
• Press the Start / Pause button
to pause the machine. The
programme follow-up light of the
relevant step during which the
machine was switched into the
pause mode will flash.
• Wait until the Loading Door can
be opened.
• Open the Loading Door and add
or take out the laundry.
• Close the Loading Door.
• Make changes in auxiliary
functions, temperature and speed
settings if necessary.
• Press Start/Pause button to start
the machine.

Child Lock

With the Child Lock function, you
can prevent children from tampering
with the machine. Thus you can
avoid any changes in a running
programme.
C
You can switch on and off
the machine with On / Off
button when the Child Lock
is active. When you switch
on the machine again,
programme will resume
from where it has stopped.
To activate the Child Lock:
Hold down the button for the 1st
Auxilliary Function for 3 seconds.
"Child Lock Enabled (CL On)"
appears on the display after the
countdown as "3_2_1" in the
programme selection display on the
panel. When this warning appears,
the 1st Auxilliary Function button
can be released.
To deactivate the Child Lock:
Hold down the button for the 1st
Auxilliary Function for 3 seconds.
After the countdown as "3_2_1" on
the programme selection display
on the panel is over, "Child Lock
Enabled (CL Off)" symbol turns off.