Furuno NAVnet VX2 Installation Manual page 38

Color video plotter
Hide thumbs Also See for NAVnet VX2:
Table of Contents

Advertisement

28. After setting up navigation equipment, press the NEXT soft key, and the GPS SETUP
menu appears. This menu sets ups the FURUNO GPS receiver GP-310B/320B. If you
do not have this equipment, press the NEXT soft key and go to step 31.
GEODETIC DATUM
WGS-84
POSITION SMOOTHING
000 second (s)
SPD/CSE SMOOTHING
005 second (s)
LATITUDE OFFSET
0.000'N
LONGITUDE OFFSET
0.000'E
DISABLE SATELLITE
- - - - - -
LATITUDE
45°35.000'N
LONGITUDE
125°00.000'W
ANTENNA HEIGHT
005 m
GPS FIX MODE
2D/3D
COLD START
NO
Installation wizard, GPS setup
29. Choose an item and press the EDIT soft key to show corresponding window.
30. Choose setting and then press the ENTER soft key. Refer to the table which follows for
description.
Item
Geodetic
Your equipment is preprogrammed with
Datum
most of the major chart systems of the
world. Although the WGS-84 system,
the GPS standard, is now widely used
other categories of charts still exist.
Select the chart system used, not the
area where your boat is sailing.
Position
When the DOP or receiving condition is
Smoothing
unfavorable, the GPS fix may change,
even if the vessel is dead in water. This
change can be reduced by smoothing
the raw GPS fixes. A setting between
000 to 999 is available. The higher
setting the more smoothed the raw
data, however too high a setting shows
response time to change in latitude and
longitude. This is especially noticeable
at high ship' speeds. Increase the
setting if the GPS fix changes.
GPS SETUP menu description
Description
28
Settings
Use the cursor
WGS-84
pad or ENTER
knob to select
appropriate
chart.
0-999 sec
0 sec (no position
smoothing)
(Con't on next page)
Default Setting

Advertisement

Table of Contents
loading

This manual is also suitable for:

1724c1743cGd-1720c

Table of Contents