Xycom XVME-500 Manual page 39

XVME-500/590 Manual
February, 1988
Flat Cable
Conductor
39
40
4 1
42
43
44
45
46
47
48
49
50
* Those channels marked by (*) are only available after an XVME-910 channel
expansion kit is installed.
2.7.2 Pl Connectors
Connectors Pl and P2 are mounted at the rear edge of the board (see Figure 2-1 or
Figure 2-2). The pin connections for Pl (a 96-pin, 3-row connector) contains the
standard address, data, and control signals necessary for the operation of VMEbus-
defined NEXP modules.
found in Appendix A of this manual). The Pl connector is designed to mechanically
interface with a VMEbus defined Pl backplane.
2.7.3 P2 Connector (XVME-590
The P2 connector is a standard VMEbus P2 backplane connector with 96-pins (3
rows). (The pin-outs for the connector P2 are found in Appendix A of this
manual.) The P2 connector is designed to interface with a VMEbus defined P2
backplane. The P2 connector for the XVME-590 will accept the input analog signals
via the user defined VMEbus pins on rows A and C (see Table 2-13).
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
Table 2-12. Input Connector JKI (cont'd)
Single-Ended
Configuration
ANALOG GND
CH. 29*
CH. 21*
ANALOG GND
CH. 22*
CH. 30*
ANALOG GND
CH. 31*
CH. 23*
ANALOG GND
POWER GND/PD GND
EXT TRIGGER
(The signal definitions and pin-outs for the connector are
Only)
Differential
Configuration
ANALOG GND
CH. 13 HI*
CH. 13 LO*
ANALOG
CH. 14 LO*
CH.
ANALOG
CH. 15 HI*
CH. 15 LO*
ANALOG GND
POWER GND/PD GND
EXT TRIGGER
2-22
GND
14 HI*
GND