Xycom XVME-500 Manual page 18

XVME-500/590 Manual
February, 1988
2 . 1 G E N E R A L
This chapter provides the information needed to configure
Input Module.
2.2 SYSTEM REQUIREMENTS
XVME-500 Analog Input Module is single-height (3U), and the XVME-590 is
The
double-height (6U) VMEbus-compatible
installed in a VMEbus backplane cardcage.
operation of the module are one of the following:
A
host processor installed in the same backplane
A)
A properly installed controller subsystem.
subsystem is the XYCOM XVME-010 System Resource Module.
A host processor which incorporates an on-board controller subsystem
B)
(such as the XVME-600 68000 Processing Module).
2.3 LOCATION OF COMPONENTS RELEVANT TO INSTALLATION
The jumpers, calibration potentiometers and connectors on the XVME-500 are
illustrated in Figure 2-1.
multiple options.
connectors on the XVME-590.
have multiple options.
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
Chapter 2
INSTALLATION
Figure 2-1A
Figure 2-2 shows the jumpers, calibration potentiometers and
Figure 2-2A
module. To operate, it must be properly
The minimum system requirements for
shows the XVME-500 jumpers which have
shows the XVME-590 jumpers which
2-1
and install the Analog
An example of such a
a