Panasonic CU-Z20VKE Series Installation Instruction page 162

Connection network using WPS mode (Method 1)
Connection Guide
Step 1 Step 2 Step 3
The router supports WPS.
Connect with WPS mode
The router does not supports WPS.
Connect with AP mode
Cancel
1. Select 'Connect with WPS mode'.
Connection Guide
Step 1 Step 2 Step 3
When the connec on of air-condi oner to router
is successful, the Wireless LAN LED changes from
blinking to ON.
*It may take up to few minutes before changes
to ON.
If the Wireless LAN LED is ON, tap "Next".
Next
If Wireless LAN LED keep blinking, tap "Check"
Check
Cancel
4. When the connection of air conditioner to
router is successful, the Wireless LAN LED
changed from blinking to ON.
Connection Guide
Step 1 Step 2 Step 3
Next
Cancel
2. Press the "WPS" button from the router
that will be connected to an air conditioner

Check the status of Wireless LAN
LED on the remote control. If the
Wireless LAN LED is OFF, press the
Wireless LAN button to enable the
Wireless LAN connection.
Connection Guide
Step 1 Step 2 Step 3
Searching for air-condi oner.
Please wait...
Cancel
5. If the Wireless LAN LED keep blinking,
check the wireless router connection.
161
Connection Guide
Step 1 Step 3
Step 2
If Wireless LAN LED is OFF during the connec on
setup, please press "Wireless LAN" bu on once
to enable the Wireless LAN before proceeding to
s e t p . 1
1. Press and hold "Wireless LAN" bu on for 5 secs
un l easy se ng " 1 " is shown .
2. Point remote control to air-condi oner and
press "SET" bu on once.
3. A er step 1 & 2 have been done, tap "Next".
SET
CANCEL
Next
Cancel
3. Ensure Wireless LAN LED is ON. Press
and hold the Wireless LAN
5 seconds until "1" is shown on the
remote control and press
to the air conditioner.
button for
pointing
SET