Table of Contents
Advertisement
REAR PANEL ASSEMBLY
1 required
81F
Absco Industries
Assembly Instruction Manual
ABSCO POOL PUMP COVER
MODEL: PPCK-PTX
5' W x 5' D x 4' 10" H
PPB
PPB
- This completes the rear panel -
FAST001
81F
Model: PPCK-PTX
1. Layout and overlap two PPB
sheets by one rib as shown.
You'll need to turn one 180
degrees.
Align them so the two rib holes
overlap and the edge holes are
to the outsides.
2. Fasten with 3/8" self tapping
screws through prepunched
sheet-to-sheet holes on overlap.
If you can't see bottom hole twist
the sheet left or right.
Make a new hole with supplied
drill bit if bottom hole is too far
up or down the sheet or not
found.
3. Attach the top and bottom
channels using the SNAP-TiTE
method.
Make sure you have the short
side of the channel to the
outside of the sheeting
27/4/23
1.0
7
Advertisement
Table of Contents
