Starting A Cycle Wash; Changing The Program Mid-Cycle; Forget To Add A Dish - Scandomestic WFO 1301 User Manual

Starting A Cycle Wash

1 Draw out the lower and upper basket, load the dishes and push them back.
It is commended to load the lower basket first, then the upper one.
2 Pour in the detergent.
3 Insert the plug into the socket. The power supply refer to last page "product fiche". Make
sure that the water supply is turned on to full pressure.
4 Close the door, press the Power button, to switch on the machine.
5 Choose a program, the response light will turn on. Then press the Start/Pause

Changing the Program Mid-cycle

A wash cycle can only be changed if it has been running for a short time otherwise, the
detergent may have already been released and the dishwasher may have already drained
the wash water. If this is the case, the dishwasher needs to be reset and the detergent
dispenser must be refilled. To reset the dishwasher, follow the instructions below:
1 Press the Start/Pause button to pause the washing.
2 Press Program button for more than 3 seconds - the program will cancel.
3 Press the Program button to select the desired program.
4 Press the Start/Pause button, after 10 seconds, the dishwasher will start.

Forget to add a dish?

A forgotten dish can be added any time before the detergent dispenser opens. If this is the
case, follow the instructions below:
1 Press the Start/Pause button to pause the washing.
2 Wait 5 seconds then open the door.
3 Add the forgotten dishes.
4 Close the door.
5 Press the Start/Pause button, the dishwasher will start after 10 seconds.
It is dangerous to open the door mid-cycle, as hot steam may scald you.
Auto Open
After washing, the door will open automatically to achieve
better drying effect.
NOTE
The dishwasher door must not be blocked when set to open automatically.
This can disrupt door lock functionality.
72