Wash Cycle Table - Scandomestic SFO 4102 W User Manual

Wash Cycle Table

* Means: Rinse-aid dispenser needs to be filled
Program Cycle Selection Information
Intensive For heaviest soiled crockery, and nor-
mally soiled pots, pans, dishes etc with
dried on soiling.
Normal For normally soiled loads, such as pot,
plates, glasses and lightly soiled pans.
ECO This is standard programme, it is suita-
ble to clean normally soiled tableware
(*EN 50242 )
and it is the most efficient programme
in terms of its combined energy and
water consumption for that type of ta-
bleware.
Glass For lightly soiled crockery and glass.
90 Min For normally soiled loads that need
quick wash.
Rapid A shorter wash for lightly soiled loads
and quick wash.
NOTE:
*EN 50242 : This programme is the test cycle. The information for comparability test in accordance with EN 50242, as follows:
Capacity: 14 settings
Position Upper basket: upper wheels on rails
Rinse aid setting: 6
PI:0.49w;Po:0.45w
Starting a cycle wash
1) Draw out the lower and upper basket, load the dishes and push them back. It is recommended toload the lower basket first, then the upper one (see
the section entitled "Loading the Dishwasher").
2) Pour in the detergent (see the section entitledSalt, Detergent and Rinse Aid).
3) Insert the plug into the socket. The power supply is 220-240 VAC /50 HZ, the specification of the socket is 10A 250VAC. Make sure that the water supply
is turned on to full pressure.
4) Open the door, touch the power button, and the On/Off light will turn on.
5) Touch the program Button, the wash program will be changed as follows direction: Eco→Glass→90min→Rapid→Soak→Intensive→Normal→Eco;
6) If a program is selected, the response light will turn on. Then close the door, the dishwasher will start its cycle.
Change the program
A cycle that is underway can only be modified if it has only been running for a short time. Otherwise, the detergent may have already been released, and
the appliance may have already drained the wash water. If this is the case, the detergent dis- penser must be refilled.
1) Press the Start/Pause button
2) Press the running program button more than 3s then you can change the program to the desired cycle setting.
If you open the door during a wash cycle, the machine will pause. The programlight will stop blinking and the buzzer will mooing every minute unless you
close the door. After you close the door, the machine will keep on working after 10 seconds.
If your model has broken remember function, the machine will go on to finish the selected program after the power cut.
Description Detergent
of cycle Pre/main
Pre- 5/30g
wash(50°C)
1or2 pieces
Wash (60°C)
Rinse Rinse
Rinse(70°C)
Drying
Pre-wash 5/30g
(45°C)
or2 pieces
Wash (55°C)
Rinse
Rinse (65°C)
Drying
Pre-wash 5/30g
Wash (45°C)
1or2 pieces
Rinse 65°C)
Drying
Pre-wash 5/30g 1 piece
Wash (40°C)
Rinse
Rinse (60°C)
Drying
Wash (65°C) 35g 1 piece
Rinse
Rinse (65°C)
Drying
Wash (45°C) 25g
Rinse (50°C)
Rinse (55°C)
Run time Energy Water con-
(min.) (Kwh) sump. (L)
205 1.621 17.8
175 1.302 14.3
220 0.937 11.0
120 1.100 14.3
90 1.350 11.7
30 0.751 11.2
Rinse
aid
*
*
*
*
*
*