Starting A Program; Changing The Program Mid-Cycle; Forget To Add A Dish - Scandomestic SFO 3806 W User Manual

consumption, and it is used to assess compliance with the EU ecodesign legislation.
Saving Energy
1. Pre-rinsing of tableware items leads to increased water and energy consumption and is
not recommended.
2. Washing tableware in a household dishwasher usually consumes less energy and water
in the use phase than hand dishwashing when the household dishwasher is used
according to the instructions.

Starting a Program

1. Draw out the lower and upper basket, load the dishes and push them back.
It is commended to load the lower basket first, then the upper one.
2. Pour in the detergent.
3. Insert the plug into the socket. The power supply refer to last page "Product fiche". Make
sure that the water supply is turned on to full pressure.
4. Open the door, Press the Power button.
5. Choose a program, the response light will turn on. Then close the door, the dishwasher
will start its cycle.

Changing the Program Mid-cycle

A program can only be changed if it has been running only for a short period of time,
otherwise the detergent may have already been released or the the wash water with
detergent has already been drained. If this is the case, the dishwasher needs to be reset
and the detergent dispenser must be refilled. To reset the dishwasher, follow the
instructions below:
1 Open the door a little to stop the dishwasher, after the spray arm stopped working, you
can open the door completely.
2 Press Program button more than three seconds the machine will be in program
selection mode.
3 You can change the program to the desired cycle setting.

Forget to add a dish?

A forgotten dish can be added any time before the detergent dispenser opens. If this is the
case, follow the instructions below:
1. Open the door a little to stop the washing.
2. After the spray arms stopped working, you can open the door completely.
3. Add the forgotten dishes.