Alamo Bush Hog 3308-2 Series Operator's Manual page 109

DRIVELINE ATTACHMENT - SLIP CLUTCH
Before starting assembly, make certain that all paint, dirt and grease are removed from
gearbox shaft. To ease assembly, apply a light coat of grease to splines, then assemble.
Do not assemble a driveline without a shield. Entanglement in rotating shafts can kill.
1. Remove tapered pin from splined clutch hub on the end of the driveshaft.
2. Open the clutch shield inspection holes to expose the gearbox input shaft and give
access to theYoke.
3. Slide the Slip Clutch end of the driveline onto the gearbox input shaft.
4. Make certain that the slip clutch is fully onto the input shaft splines.
5. Align the tapered pin hole in the hub with the grove on the input shaft.
6. Install the tapered pin, washer and locknut. Torque the nut to 30 ft./lbs.
3308-2 Series 09/20
© 2020 Alamo Group Inc.
ASSEMBLY
DRIVELINE ATTACHMENT
Assembly Section 3-13