Alamo Bush Hog 3308-2 Series Operator's Manual page 101

3 POINT LIFT MODEL ASSEMBLY
RH
Mast
3/4"
Locknut
Cat I QH
Top Bushing
5/8" x 2"
Capscrew
1" Hex
Nut
1"
Lockwasher
1. Remove the mast from the shipping position and attach the LH and RH Mast to the inside of the inner
mount plates using the rear holes. Install the 2 Strut Bushings in the holes of the Mast. Install using the
5/8" x 2" capscrew, 5/8 SAE flatwasher and 5/8" locknut. Make sure the 5/8" flatwasher is installed to
the inside against the bushing in order to retain it in the mast.
2. Assemble the mast halves by placing the CAT I Quick Hitch Top Bushing between the mast in the lower
hole and install the 3/4" x 4" capscrew and 3/4" locknut.
3. Attach the RH and LH pivot arm halves to the top holes on the mast. Place the mast spacer between
the mast and the pivot arms halves to the outside of the mast. Place a spacer bushing in each pivot
arm and install a 3/4" x 5-1/2" Capscrew and 3/4" Locknut.
4. Install the Driveline Holder to the right hand inside strut using the hole the shipping stand was bolted to.
Use the 1" x 2-1/2" capscrew, 1" lockwasher and 1" hex nut to attach the Driveline Holder.
SEMI MOUNT MODEL ASSEMBLY
1. Semi Mount Models do not require the Mast or Struts and Flex Links used on the 3 Point Lift models.
2. Cat.I Hitch Pins with Cat. II Bushings and Spacer Bushings are shipped installed to the lift points of the
cutter.
3. Install the Driveline Holder to the right hand inside strut using the hole the shipping stand was bolted to.
Use the 1" x 2-1/2" capscrew, 1" lockwasher and 1" hex nut to attach the Driveline Holder.
3308-2 Series 09/20
© 2020 Alamo Group Inc.
ASSEMBLY
Spacer Mast
3/4"
Bushing Spacer
Locknut
Driveline
Holder
7/16" x 2"
1" x 2-1/2"
Lynch Pin
Capscrew
Assembly Section 3-5
Spacer
Bushing
3/4" x 2-1/2"
Capscrew
Spacer
Spacer
7/8" x 7"
Cat II
Htch Pin
3/4"
Flatwasher
3/4"
Locknut
Spacer
Bushing
3/4" x 5-1/2"
Capscrew
3/4" x 4"
Capscrew
Strut
Bushing
5/8"
Flatwasher
LH
Mast
5/8"
Locknut