Alamo Bush Hog 3308-2 Series Operator's Manual page 100

1. Install (2) bushings between the LH and RH Struts using 3/4" x 2-1/2" capscrews and 3/4" lock-
nuts at each location.
2. Place the LH and RH Flex Yokes together and align the slotted holes. Place a Bushing into
the slotted holes.
3. Install the Flex Yokes with Bushing between the Struts so the slanted end is toward the ground
and rest atop the bushing previously installed. Align the holes of the struts and the bushing in
the yokes.
4. Insert a 3/4" x 2-1/2" Capscrew and fasten with a 3/4" Locknut.
5. Tighten all fasteners.
RH Flex Yoke
LH Flex Yoke
Bushing into slotted hole
3308-2 Series 09/20
© 2020 Alamo Group Inc.
ASSEMBLY
3 POINT LIFT MODEL ASSEMBLY
3308-2 Lift Model
FLEX LINK ASSEMBLY
Bushings
Between Struts
Assembly Section 3-4
RH Strut
Capscrews 3/4" x 2-1/2"
and Locknuts 3/4"
LH Strut