Table of Contents
Advertisement
Before installing any tires and wheels make certain the Cutter is jacked up high enough and is securely sup-
ported. When installing laminated or airplane tires, be sure the flat side of the lug nut is against the wheel.
There are only three types of tires that can be used on this cutter DO NOT USE ANY OTHER TYPE OF
TIRE OR WHEEL, such as automutive tires and rims. DO NOT EXCEED THE MAXIMUM SPEED FOR
EACH TYPE OF TIRE. Excessive speed can cause damage to the machine, tire and wheel.
When installing Laminated Tires and Wheels note the direction of travel and curvature of rubber segments
of the tire and install as shown in illustration below. Do not exceed 20 M.P.H. on Lamianted Tires.
Before seperating wheel halves on Airplane Tires,let all the air out ouf the tire by removing the valve core to
make certain no air pressure is left in the tube befor seperating the wheel halves to dismount tire.
*DO NOT LOOSEN WHEEL CLAMP BOLTS BEFORE PRESSURE IS REMOVED FROM TUBE AND
TIRE TO PREVENT EXPLOSIVE SEPERATION OF WHEEL HALVES WITH POSSIBLE SERIOUS BODILY IN-
JURY.
Place Flatside of
Lug Nut Against Wheel
3308-2 Series
09/20
© 2020 Alamo Group Inc.
ASSEMBLY
TIRES AND WHEELS
NOTE SEGMENT
CURVATURE
LAMINATED TIRE
Place Flatside of
Lug Nut Against Wheel
FOAM FILLED TIRE
MAXIMUM INFLATION
PRESSURE 40 PSI
MAXIMUM SPEED 20 MPH
AIRPLANE TIRE
Assembly Section 3-11
*Wheel Clamp Bolts
Lugnuts
*Wheel Clamp Bolts
Lugnuts
Advertisement
Chapters
Table of Contents
