Alamo Bush Hog 3308-2 Series Operator's Manual page 102

SWING HITCH MODEL ASSEMBLY
1. 3308 Swing Hitch Models are shipped with the Swing Hitch assembled to the machine. The hydraulic
cylinder that controls the swing hitch will be installed along with the hydraulic lines. Refer to the detail
below for this installation.
2. Attach the base end of the hydraulic cylinder to the outer cylinder mount and pin in place.
3. Pin the Rod End of the Cylinder to the lug on the LH swing arm.
4. Place the two 90º Hydraulic Fittings in the cylinder ports at the base end and the rod end and tighten.
5. Attach the hydraulic hoses to the 90º elbow fittings and tighten.
3308-2 Series 09/20
© 2020 Alamo Group Inc.
ASSEMBLY
Lug on
Swing Arm
Hydraulic
Hoses
Assembly Section 3-6
Hydraulic
Hydraulic
Cylinder
Cylinder
Rod End
Base End
90º Hydraulic
Elbows