Table of Contents
Advertisement
24. Maintain tools with care. Keep saw blades sharp
and clean for the best and safest performance.
Follow instructions for lubricating and changing
accessories.
25. Turn off the machine before cleaning. Use a brush
or compressed air to remove chips or debris — do
not use your hands.
26. Do not stand on the machine. Serious injury could
occur if the machine tips over.
27. Never leave the machine running unattended.
Turn the power off and do not leave the machine
until it comes to a complete stop.
28. Remove loose items and unnecessary workpieces
from the area before starting the machine.
29. Keep hands and fingers away from moving saw
blade.
30. Don't use in dangerous environment. Don't use
power tools in damp or wet location, or expose
them to rain. Keep work area well lighted.
Additional Safety Instructions for
Scroll Saws
31. Scroll saw must be secured to a sturdy foundation.
If there is a tendency for the stand or workbench
to move, it must also be secured to the floor.
32. Blade
must
be
operating. Failure to do so could result in blade
breakage and possible injury.
33. Never start saw with workpiece contacting blade.
34. Always keep fingers and hands away from blade.
Avoid awkward hand positions where a sudden
slip might cause hand to move into or toward the
blade.
35. Always hold stock firmly against table. The
provided
hold-down
positioned over the workpiece.
36. Do not attempt to saw any stock that does not
have a flat surface, without a suitable support. Do
properly
tensioned
before
should
be
correctly
not cut pieces of material too small to hold by
hand.
37. Care must be taken when cutting material with an
irregular cross section. The blade could pinch
before the cut is completed. Any stock, such as
frame molding, must lie flat on the table surface
and not be allowed to rock.
38. Dowels or tubing have a tendency to roll while
being cut and cause the blade to "bite." Round
material should be held firmly against the table.
39. Turn off saw before backing stock out of an
incomplete cut. Only remove jammed cut-off
pieces after blade has stopped.
40. Make "relief" cuts before cutting long curves.
41. When cutting large or oversize stock, always make
sure material is supported at table height.
42. Do not feed workpiece too fast while cutting. Feed
workpiece only fast enough for the blade to cut.
43. Never reach under the table while blade is moving.
WARNING: This product can expose you to
chemicals including lead and cadmium which
are known to the State of California to cause
cancer and birth defects or other reproductive
harm, and phthalates which are known to the
State of California to cause birth defects or other
reproductive harm. For more information go to
http://www.p65warnings.ca.gov.
WARNING: Drilling, sawing, sanding, or
machining wood products generates wood
dust and other substances known to the State
of California to cause cancer. Avoid inhaling
dust generated from wood products or use a
dust mask or other safeguards for personal
protection.
Wood products emit chemicals known to the
State of California to cause birth defects or
other reproductive harm. For more information
go to http://www.p65warnings.ca.gov/wood.
8
8
Advertisement
Table of Contents
