Sena NS10 User Manual page 3

You can easily adjust the volume by tapping the (+) Button or the (-) Button. You will hear a beep when the volume
reaches maximum or minimum level. The volume is set and maintained independently at different levels for each audio
source even when you turn off and on the headset. For example, once you set the volume for mobile phone handsfree, it
will not change even if you adjust the volume when you hear Bluetooth MP3 music. So you can always maintain the
preferred optimum volume level for each audio source.
3. NS10 CONFIGURATION SETTING
You can set the configuration of the NS10 by the voice menu instruction as below.
1. To enter into voice configuration menu, press and hold the Center Button for 10 seconds until the LED shows solid
blue and you hear high tone double beeps. You will also hear a voice prompt, "Configuration menu".
2. Tap the (+) Button or (-) Button to navigate between the menus. You will hear voice prompts for each menu items as
below.
3. You can enable / disable the feature or execute the command by tapping the Center Button.
4. If you want to exit the configuration immediately, tap the (+) Button or (-) Button until you hear a voice prompt, "Exit
configuration", then tap the Center Button.
The voice prompt for each menu item is as follows:
(1) Phone pairing
(2) Multipoint pairing
(3) Phone selective pairing
(4) Media Selective pairing
(5) VOX phone
(6) VOX intercom
(7) VOX sensitivity
(8) Voice prompt
(9) Delete all pairings
(10) Factory reset
(11) Exit configuration
3.1 Mobile Phone Pairing
Voice Prompt
Factory Default
"Phone pairing"
N/A
3
| NS10