Table of Contents
Advertisement
APPENDIX
•
Setting the desired temperature
○ When the unit is turned on the controller display will show the current
temperature and set value.
○ Press and hold the SET button for 2 seconds to set a different
temperature. Use up and down keys to reach the desired set
temperature. Once the controller read out shows the desired
temperature, press SET key again.
○ The oven will now automatically heat up or cool down to the set
temperature. The oven will automatically turn off heating when the set
temperature is reached. The green lamp will also turn off.
•
To use the welding powder, place a 5-gallon bucket underneath the oven spout. Pull
the lower arm to discharge powder into the bucket. When the bucket is full or enough
flux has been removed, push back the arm.
○ Open and release the release valve on the top to avoid the hot smoke
exhaust when opening the front door/
APPENDIX
ORDERING NUMBERS
Ordering number
0700 100 000
Stationary submerged arc welding powder
Technical documentation is available on the Internet at:
0448 020 001
Denomination
drying oven
www.esab.com
- 6 -
Type
Notes
SDF-
Three phase
250
380-
415 V AC 50/60 Hz
© ESAB AB 2023
Advertisement
Table of Contents
