ICON NprdicTrack VIEWPOINT 3600 User Manual page 10

7. Remove the band securing the Upright Wire
Harness (73) to the right Upright (85). Have a
second person hold the console assembly near
the right Upright.
Connect the Upright Wire Harness (73) to the
wire harness on the console assembly. See the
inset drawing. The connectors should slide
together easily and snap into place. If they do
not, turn one connector and try again. IF THE
CONNECTORS ARE NOT CONNECTED
PROPERLY, THE CONSOLE MAY BE DAM-
AGED WHEN THE POWER IS TURNED ON.
Then, insert the connectors into the right Upright
(85).
8. Remove the band securing the TV Cable (112)
to the left Upright (85). Connect the TV Cable to
the cable extending from the console assembly.
Then, insert the TV Cable into the left Upright.
Next, insert the brackets on the Handrails (70)
into the Uprights (85). Make sure that no wires
are pinched.
9. Attach the console assembly to the Uprights
(85) with four 3/8" x 1 1/4" Bolts (72) and four
3/8" Star Washers (67) (only one side is shown).
Start all four Bolts before tightening any of
them.
7
Console
Assembly
73
85
Wire
Harness
8
Cable
Console
Assembly
9
85
67
10
73
Wire
Harness
Bracket
70
112
85
72
Console
Assembly