Table of Contents
Advertisement
Design and function
5
Risk of injury from electrical voltage!
Contact with live parts, e.g. power connections, can be fatal!
•
Observe the safety information on the first pages of the operating instructions!
•
Commissioning must be carried out by persons who are specifically trained in handling
power sources!
•
Connect connection or power cables while the machine is switched off!
Risk from electrical current!
If welding is carried out alternately using different methods and if a welding torch and
an electrode holder remain connected to the machine, the open-circuit/welding voltage
is applied simultaneously on all cables.
•
The torch and the electrode holder should therefore always be placed on an insulated
surface before starting work and during breaks.
Read and observe the documentation to all system and accessory components!
5.1
Transport and installation
5.1.1
Lifting by crane
Risk of injury during lifting by crane
When lifting the machine by crane, persons may be severely injured by falling machines
or mount-on components.
•
Simultaneous lifting of system components such as power source
feeder or cooling unit without suitable crane components is not
allowed. Each system component has to be lifted separately!
•
Remove any supply leads and accessories before lifting by crane (e.g.
hose package
remote control,etc.)!)
•
Properly close and lock all casing covers and protective caps before
lifting by crane!
•
Use the correct number of hoisting equipment of the right size in the
correct position! Observe craning principle (see figure)!
•
For machines with lifting eyes: always lift all lifting eyes simultaneously
•
When using retrofitted craning frames etc.: always use at least two
lifting points positioned as far apart as possible – observe option
description.
•
Avoid any jerky movements!
•
Ensure that the load is distributed evenly! • Use chain hoists and
chain slings of the same length only!
•
Stay outside the danger zone underneath the machine!
•
Observe the regulations regarding occupational safety and accident
prevention for the respective country.
099-000251-EW501
27.10.2017
WARNING
WARNING
!
wire spool
shielding gas cylinder
,
,
Design and function
CAUTION
toolbox, wire feeder
,
Transport and installation
wire
,
,
!
Craning principle
17
Advertisement
Table of Contents
Need help?
Do you have a question about the Tetrix 451 AC/DC Smart 2.0 FW and is the answer not in the manual?
Questions and answers