Error Messages - Sharp MDMT877 Operation Manual

Error Messages : continued

ERROR MESSAGES

NO DISC
A disc has not been loaded.
NO SIGNAL
Poor connection of the digital cable.
(noSIG.) No output signal comes out from the connected
unit to playback.
The input signal has improper sampling fre-
quency.
PLAY MD
You recorded on a playback-only disc.
(PLAYmd)
POWER ?
The battery charger is defective.
PROTECTED
The write protection tab of a MiniDisc is set to
the protected position.
You tried to record on a playback-only disc.
SORRY
Since a track number is currently being located
(Sorry) or updated, the unit cannot accept your com-
mand.
TEMP OVER
The temperature is too high.
(TEMP!)
TOC FORM **
There is an error in the recording signal.
(Tform**)
TOC FULL
There is no space left for recording character
information (track names, disc names, etc.).
Tr. Protect
The track has been protected from being erased.
? DISC
A disc which contains data other than music was
(? DISC) played.
There is an error in the signal recorded on the
disc.
Stamping is not possible.
( ) : Error messages seen on the remote control.
Number or symbol appears in * position.
MEANING
Load a disc.
Connect the digital cable securely.
If the portable CD player has a function to prevent sound
skips, deactivate it.
Playback with the connected unit.
Replace it with a recordable disc.
To have it repaired, go to the distributor where you
purchased the unit.
Move the write protection tab back to its original position.
Replace it with a recordable MiniDisc.
Wait for a while and try the operation again.
Turn off the power, and wait for a while.
Erase all of the tracks, and then record again.
Replace it with another recordable disc.
Edit the track with the device on which it was recorded.
A disc which contains non-music data cannot be played.
Replace it with another recorded disc.
Retry.
REMEDY
55