Sharp MDMT877 Operation Manual page 21

Recording : continued
1
Press the REC button.
The record pause mode is entered.
2
Begin playback on the stereo system con-
nected to this portable MD.
To enable the record level to be set.
3
Press the 5 5 or 4 4 button to adjust the
5 5 5 4 4 4
recording level.
Analog recording
Adjust the recording level so that the maximum
sound volume from the source makes the reading
swing somewhere between –4 dB and 0 dB.
Level meter indicator
Digital recording
You can adjust the level in 1 dB increments within
the range of +12 - –12dB.
Once you adjust the digital recording level, the set-
ting remains even after the recording stops. (For
cancellation instructions, see page 41.)
4
Press the PAUSE button on the stereo sys-
tem to enter the playback pause mode at
the point you wish to start recording.
Here you can select the track to be recorded.
5
Press the MODE button repeatedly to se-
lect the recording mode (page 32).
6
0dB Press the 06 06 button to start the MiniDisc
06 06 06
unit recording.
4dB
7
Begin playback on the stereo system, the
output will be recorded.
+12 - –12dB Notes:
When recording, it is recommended to use the AC adap-
tor and also install the charged battery. Should the power
failure occur, the power source would be automatically
switched to the rechargeable battery.
Changing the volume level while recording does not af-
fect the recording.
You cannot adjust the bass level while recording.
( Stereo recoding )
( 2 times long recording )
( 4 times long recording )
( Monaural recording )
21