Error Messages - Sharp MD-SR75H Operation Manual

Error Messages

ERROR MESSAGES
BATT EMPTY The battery is run down.
(LoBATT)
BLANK MD Nothing is recorded.
(BLANK)
Can't COPY You tried to record from a copy pro-
hibited MiniDisc.
(Can'tC)
Can't EDIT
A track cannot be edited.
(Can'tE)
Can't READ (*) The disc data cannot be read be-
(Can'tS) cause the disc is damaged.
(Can'tT)
(Can'tU)
Recording cannot be performed cor-
Can't REC
rectly due to vibration or shock.
(Can'tR)
Stamp function does not work.
Can't STAMP
Cannot save the TOC information
Can't WRITE
correctly to a MiniDisc. (A large por-
(Can'tW)
tion of the disc has been damaged.)
The disc is scratched.
DEFECT
(DEFECT)
DISC FULL The disc is out of recording space.
The microprocessor has reported a
Er-MD (**)
system fault and the unit is out of or-
(ErMD*)
der.
HOLD The unit is in the hold mode.
(HOLD)
You removed a MiniDisc whilst re-
LOCKED
cording or editing.
(Can'tLOCK)
( ) : Error messages seen on the remote control.
Number or symbol appears in (*) position.
42
Web-site: www.sharp.co.uk/support
MEANING
Charge the rechargeable battery or replace the alka-
line battery (or use the AC adaptor for power).
Replace the disc with a recorded disc.
Record using the analogue cable.
Change the stop position of the track and then edit it.
Reload the disc.
Replace it with another recorded disc.
Re-record or replace it with another recordable disc.
Check the number of tracks.
Replace the disc with another recordable disc.
If the sound you hear is not right, record again.
Replace the disc with another recordable disc.
Replace it with another recordable disc.
To have it repaired, go to the distributor where you
purchased the unit.
Return the HOLD switch to its original position.
Turn off the power and remove the MiniDisc.
Help Line: 0990 274277 (office hours)
REMEDY