Error Messages - Sharp MDMT877 Operation Manual

Error Messages

ERROR MESSAGES
BATT EMPTY
The battery is run down.
(LoBATT)
BLANK MD
Nothing is recorded.
(BLANK)
Can't COPY
You tried to record from a copy prohibited
(Can'tC)
MiniDisc.
Can't EDIT
A track cannot be edited.
(Can'tE)
Can't READ *
The disc data cannot be read because the disc
(Can'tS)
is damaged.
(Can'tT)
(Can'tU)
Can't REC
Recording cannot be performed correctly due to
(Can'tR)
vibration or shock.
Can't STAMP
Stamp function does not work.
Can't WRITE
Cannot save the TOC information correctly to a
(Can'tW) MiniDisc. (A large portion of the disc has been
damaged.)
CHARGEmode
The Charge/Operation switch is not set to the
operation mode when using this unit with the AC
adaptor.
DEFECT
The disc is scratched.
(DEFECT)
DISC FULL
The disc is out of recording space.
Er-MD **
The microprocessor has reported a system fault
(ErMD*) and the unit is out of order.
HOLD
The unit is in the hold mode.
(HOLD)
LOCKED
You removed a MiniDisc while recording or
(Can'tLOCK)
editing.
54
MEANING
Charge the rechargeable battery or replace the alka-
line battery (or use the AC adaptor for power).
Replace the disc with a recorded disc.
Record using the analog cable.
Change the stop position of the track and then edit it.
Reload the disc.
Replace it with another recorded disc.
Re-record or replace it with another recordable disc.
Check the number of tracks.
Replace the disc with another recordable disc.
Set the Charge/Operation switch to the operation mode.
If the sound you hear is not right, record again.
Replace the disc with another recordable disc.
Replace it with another recordable disc.
To have it repaired, go to the distributor where you pur-
chased the unit.
Return the HOLD switch to its original position.
Turn off the power and remove the MiniDisc.
REMEDY