Adjustment; Adjustment Of Image Registration - MINOLTA-QMS PagePro 1200 Series Service Manual

6.

Adjustment

6-1.

Adjustment of Image Registration

After Mechanical Control Board (Controller Board) is replaced, be sure to make a print of an image
sample.
If the starting position of the image (registration gap (d)=4mm) in the sub-scanning direction is not
suitable, adjust the gap by following the procedure described below.
1. Remove the Right Cover so that the variable resistor (PagePro 1250E: VR101, or PagePro
1200W: VR1) on the Controller Board can be adjusted.
2. Turn the variable resistor on the Controller Board so that d measures 4 mm.
PagePro 1250E shown below:
d
4 mm
PagePro 1200W shown below:
d
4 mm
PagePro 1200 Series Adjustment
VR101
VR1
87
6
PJ2