Weber SmokeFire STEALTH EPX4 Owner's Manual page 37

Fuse Replacement
If your SMOKEFIRE barbecue is non-responsive even after securing all
electrical connections, it is possible that the barbecue's fuse has blown. The
barbecue's power supply utilises a cartridge fuse. This simple and inexpensive
part can be easily replaced with the following instructions:
CAUTION: Only use the properly sized and rated fuse when replacing. Failure to
do so will void your warranty. The correct fuse is:
1.6A
250V
5x20mm
Fast blow
1. Make sure that the barbecue is completely cool, then power off and
unplug the barbecue from the power source (A).
2. The fuse is installed inside the fuse holder located on the underside of
the hopper. Use a flathead screwdriver to gently pry open the fuse holder
and remove the fuse (B).
NOTE: WEBER recommends replacing the fuse if there is suspicion of failure.
3. Install a new fuse into the fuse holder and reinstall the fuse holder into
the power module (C).
CAUTION: Make sure the fuse holder is fully installed and closed before operating
your barbecue.
4. Plug in, power on the barbecue, and begin a cooking session to allow the
controller to run diagnostics.
CALL
CUSTOMER
SERVICE
If you are still experiencing any
problems, contact the Customer
Service Representative in your area
using the contact information
on weber.com.
REPLACEMENT
PARTS
To obtain replacement parts,
contact the local retailer
in your area or log onto
weber.com.
TROUBLESHOOTING
A
B
C
37
weber.com