Weber SmokeFire STEALTH EPX4 Owner's Manual page 28

TROUBLESHOOTING
E3 Barbecue Flame is Out
Barbecue Flame Out Procedure
To clear the E3 error code from the controller, please follow these steps:
1. The barbecue will automatically run the shutdown procedure if
the barbecue is still hot. Open the barbecue lid and wait until the
barbecue has completed the shutdown procedure and completely
cooled.
CAUTION: Do not unplug the barbecue or power it off during the shutdown
procedure.
2. Once the shutdown procedure is complete, power off the barbecue
and unplug from the power source.
3. Open the barbecue lid and remove the cooking grates, FLAVORIZER
bars, heat diffuser, and heat baffle from the cookbox (A).
4. Clean the cookbox and burn pot of any ash or debris using a barbecue
brush or scraper to direct it into the ash and grease system (B).
CAUTION: Allow time for the ash and debris to fully extinguish before cleaning
the barbecue.
5. From the rear of your SMOKEFIRE barbecue, place a large bucket or
container underneath the middle of the hopper (C).
6. Pull the hopper slide door located on the rear of the hopper to
release the pellets into the container below (D). Scoop any excess
pellets left inside the hopper through the hopper slide door.
7. From the rear of your SMOKEFIRE barbecue, remove the rear access
panel by removing four screws (E).
8. Disconnect the wire connection from the motor by pinching the clip
and pulling the quick disconnect plug. (F).
A
B
28
C
D
E
F