Weber SmokeFire STEALTH EPX4 Owner's Manual page 23

Error Code
E6
E7
E8
E9
Cause
CAUTION: Do not unplug the barbecue or power it off during the shutdown procedure.
CAUTION: Allow time for the ash and debris to fully extinguish before cleaning the barbecue.
Start Up Failure
WARNING: Do not touch the glow plug to check if it is hot. If the glow plug is operating
correctly, it will start to glow in colour as it heats.
If the glow plug is operating correctly:
NOTE: If you continue to experience startup failure, empty the hopper using the pellet slide
door and check for any obstructions at the auger.
If the glow plug is not operating correctly:
• The barbecue will remain cool and will not ignite. Shutdown the barbecue by pressing
The barbecue will automatically run the shutdown procedure if the barbecue is still hot.
Open the barbecue lid and wait until the barbecue has completed the shutdown procedure
and completely cooled.
CAUTION: Do not unplug the barbecue or power it off during the shutdown procedure.
Motor Failure
See the following instructions on how to check the motor's electrical connection. If
the motor is not operating after securing the motor connection, contact the Customer
Service Representative in your area using the contact information on our website for a
replacement motor.
The barbecue will automatically run the shutdown procedure if the barbecue is still hot.
Open the barbecue lid and wait until the barbecue has completed the shutdown procedure
and completely cooled.
Thermocouple Error
CAUTION: Do not unplug the barbecue or power it off during the shutdown procedure.
Contact the Customer Service Representative in your area using the contact information
on our website to replace the thermocouple.
The barbecue will automatically run the shutdown procedure if the barbecue is still hot.
Open the barbecue lid and wait until the barbecue has completed the shutdown procedure
and completely cooled.
CAUTION: Do not unplug the barbecue or power it off during the shutdown procedure.
Low Fuel Detection Error
See the following instructions on how to clean the low fuel sensor window. If the low
fuel sensor is not operating properly after cleaning, contact the Customer Service
Representative in your area using the contact information on our website for low fuel
sensor replacement.
TROUBLESHOOTING
1. The barbecue will automatically run the shutdown procedure if the barbecue is still
hot. Open the barbecue lid and wait until the barbecue has completed the shutdown
procedure and completely cooled.
2. Once the shutdown procedure is complete, power off the barbecue and unplug from
the power source.
3. Open the barbecue lid and remove the cooking grates, FLAVORIZER BARS, heat
diffuser, and heat baffle from the cookbox.
4. Clean the cookbox and burn pot of any ash or debris using a barbecue brush or
scraper to direct it into the ash and grease system.
5. Remove and clean any ash or grease from inside the ash and grease system. Once
cleaned, reinstall the drawer. Replace disposable drip pans as needed.
6. Plug the barbecue into the power source and power on the barbecue.
7. Turn and push the dial on the controller to select 200°C as your barbecue
temperature.
8. As the barbecue starts to preheat, visually inspect the glow plug at the bottom of the
cookbox.
9. Reinstall the heat baffle, heat diffuser, FLAVORIZER bars and cooking grates inside
the cookbox.
and holding the dial on the controller. Contact the Customer Service Representative in
your area using the contact information on our website for glow plug replacement.
Solution
23
weber.com