Installing The Tbus-6 Table Connection Bus; Cutting An Opening In The Table; Table 2: Tbus-6 Connecting Surface Features - Kramer TBUS-6 User Manual

# Feature
1 Power Socket 1
2 USB connector 1
3 Ethernet connector 1
4 Ethernet connector 2
5 USB connector 2
6 Power Socket 2
7 Audio connector 1
8 PC connector 1
9 Audio connector 2
10 PC connector 2
5

Installing the TBUS-6 Table Connection Bus

To install the TBUS-6, perform the following steps:
1. Cut an opening in the table (see section 5.1).
2. Adjust the height of the connecting surface (see section 5.2).
3. Install optional insert (see section 5.3).
4. Install the TBUS-6 in the cut-out opening (see section 5.4).
5. Connect the cables (see section 5.5).

5.1 Cutting an Opening in the Table

To cut an opening in the table:
1. Place the included cut-out template on the surface of the table where you want
to install the TBUS-6.
2. Attach the template to the table with the included screws.
3. Following the inside edge of the template, cut a hole in the table surface with a
sabre or keyhole saw according to the dimensions shown in Figure 4 (not to
scale).
Note: The thickness of the table should be 3 inches or less.
6
Installing the TBUS-6 Table Connection Bus

Table 2: TBUS-6 Connecting Surface Features

Power socket for PC1
USB-A (female / female)
RJ-45 (female / female)
RJ-45 (female / female)
USB-A (female / female)
Power socket for PC2
3.5 mm stereo audio (female / female)
Computer graphics 15-pin HD (female / female)
3.5 mm stereo audio (female / female)
Computer graphics 15-pin HD (female / female)
Function
KRAMER: SIMPLE CREATIVE TECHNOLOGY