Continue Mode / Stop Mode Settings Of Toner Cartridge; Drum Cleaning - Brother DCP-7057 Service Manual

2.4

Continue mode / Stop mode settings of Toner cartridge

You can set the machine to continue printing after the LCD shows "Replace Toner". The
machine will continue printing until the LCD shows "Toner Ended". The default setting is
"Stop".
<Models with numeric keys>
(1) Press the Menu button, and then press the 1, 8 in this order.
(2) Press the
(3) Press the OK button.
(4) Press the Stop/Exit button, the machine goes back to the ready states.
<Models without numeric keys>
(1) Press the Menu button.
(2) Press the
the OK button.
(3) Press the
the OK button.
(4) Press the
(5) Press the Stop/Exit button, the machine goes back to the ready states.
Note:
• Printing is not guaranteed in the continue mode.
• If the toner cartridge is replaced, the machine returns to the default setting.
2.5

Drum Cleaning

■ Drum cleaning function overview
Install the plain paper into the manual feed slot and perform the cleaning of the drum.
<Operating Procedure>
(1) Open the back cover while the machine is in the ready state.
(2) Press the Clear and Menu buttons at the same time. "Insert the blank paper into the
Manual feed slot." is displayed on the LCD.
(3) Install the paper into the manual feed slot.
(4) The drum cleaning is performed. "Please Wait" is displayed on the LCD.
(5) The paper is ejected from the back cover, and the drum cleaning is completed
(6) Close the back cover, and the machine goes back to the ready state.
Note:
• When the error of jam during the drum cleaning, drum cleaning mode is canceled
automatically and becomes the error display.
or button to choose continue or stop.
or button, then the "1. General Setup" will appear on the LCD and press
or button, then the "4. Replace Toner" will appear on the LCD and press
or button, then select the "Continue" or "Stop" and press the OK button.
5-41
Confidential