Fuser Fan - Brother DCP-7057 Service Manual

9.22

Fuser Fan

(1) Disconnect the connector of the fuser fan from the high voltage power supply PCB
ASSY.
(2) Remove the harness of the fuser fan from the guides of the main frame R ASSY.
(3) Release the hooks to remove the fuser fan.
High voltage power supply PCB ASSY
Hook
Label
Assembling Note:
• When assembling the fan motor 60 ASSY, attach the fuser fan after inserting the
harness into the guides of the main frame R ASSY.
• When assembling the fuser fan, place it so that the attached label faces outwards.
• When assembling the fuser fan, secure the harness to the position of figure above with
the tape.
Hook
Fan motor 60 ASSY
Fig. 3-76
3-88
Connector
Guides
Tape
Main frame R ASSY
Confidential