Table of Contents
Advertisement
Fault
The programme dura-
tion changes during
the wash cycle.
Drum jerks after the
programme starts.
Detergent or fabric
softener drips off the
seal and collects on
the door or in the seal
fold.
Fluff on the laundry.
Fabric softener re-
mains in the detergent
drawer.
The laundry is too
damp.
Cause and troubleshooting
The programme operation is optimised electronically.
This may change the programme duration.
Not a fault – no action required.
▶
The unbalanced load detection system eliminates an
imbalance by repeatedly redistributing the laundry.
Not a fault – no action required.
▶
Note: When loading, where possible, place large and
small items of laundry together in the drum. Different
sized items of laundry distribute themselves better
during the spin cycle.
Foam detection system switches on a rinse cycle if
foam build-up is too high.
Not a fault – no action required.
▶
This is caused by an internal motor test.
Not a fault – no action required.
▶
Too much detergent/fabric softener in the detergent
drawer.
When dosing liquid detergent and fabric softener,
▶
observe the marking in the detergent drawer and
do not dose above this.
Fluff has accumulated in the drum.
Run the
Baumwolle 90°C programme without
▶
any laundry or detergent.
The use of fabric softener is not supported for the se-
lected programme.
Before washing, check whether the use of fabric
▶
softener is supported for the selected programme.
→ "Programmes", Page 27
Unsuitable programme for the type of fabric.
There has been a power cut.
Check whether the lighting in your kitchen or other
▶
appliances are working.
The load is too large.
After the end of the programme, warm laundry feels
damper than it actually is.
Remove the laundry from the drum as soon as the
1.
drying programme has finished.
Spread the items of laundry for cooling.
2.
Drying target not adjusted.
Load too small.
Troubleshooting en
51
Advertisement
Table of Contents
