Table of Contents
Advertisement
Fault
flashes.
flashes.
"H:95" lights up altern-
ately with "End".
All other error codes.
The drying time is too
long.
Cause and troubleshooting
Laundry is caught in the door.
Remove any trapped laundry.
▶
The automatic voltage control system detects an un-
authorised voltage under-usage.
No remedial action possible.
▶
Note: If the power supply is stable, the programme
continues to run as normal.
Voltage under-usage may cause extension of a pro-
gramme.
No remedial action possible.
Detergent dosage is too high.
Immediate measure: Mix one tablespoon of fabric
▶
softener with 0.5 litres of water and pour the mix-
ture into the left-hand compartment (not for outdoor
clothing, sportswear or items stuffed with down).
Reduce the amount of detergent for the next wash-
▶
ing cycle with the same load.
Drum cleaning is required.
→ "Cleaning the drum", Page 39
▶
The water pressure is low.
See
▶
→ "E:30 / -10 and/or
Malfunction
Switch the appliance off and then on again.
1.
If the message appears again, disconnect the appli-
2.
ance from the power supply for at least 30 seconds
by pulling out the plug or by switching off the relev-
ant circuit breaker in the fuse box.
If the fault was a one-off, the message disappears.
a
If the message appears again, call the after-sales
3.
service. Please specify the exact error message
when calling.
→ "Customer Service", Page 55
The ambient temperature is greater than 30 °C.
Ensure that the ambient temperature is below 30
▶
°C.
Insufficient air circulation at the appliance's installation
location.
Ventilate the appliance's installation location.
▶
Fluff has accumulated in the drum.
Troubleshooting en
", Page 44
45
Advertisement
Table of Contents
