Before Start - Fuel And Chain Oil; Start - Texas A/S TBS 4518 User Manual

6. Before start - fuel and chain oil

Mix leadless gasoline octane 95 with approved semi-synthetic 2-stroke oil
We recommend Tex-Part oil Motex 2 TX with a 2% mixture.
If other types of oil are used - a mixture of 4% is recommended - you shall
Always follow the guidelines of the oil manufacturer on the back of the oil can.
Avoid open fire close to where you fill with fuel. Draw attention to the presence of dirt or
water in the fuel. Always store the fuel in a clean and approved container.
Use always chain oil for lubrication of bar and chain. Texas recommends Klingtex chain oil
viscosity 125.

7. Start

1) Fill with chain oil (1) and fuel (2)
2) Make sure the stop switch and chain brake is not activated
3) Release the stop/start switch (3)
4) Pull out the choker (7)
5) While the saw is kept safely on the ground with one foot
inside the rear handle and left hand on the front handle,
the starter handle is being pulled a few times with right
hand until you hear an "explosion"
6) Activate the throttle control (5). The choke will automatically
be pulled in. Above procedure is repeated 1-3 times.
Now the saw will start
7) Push down the safety button (6) and activate the throttle
control (5).
8) Let the saw warm up before using it, and control the choke
is fully pressed in.
Warning: Keep clear of the chain as it will start moving
when the saw is started. Only start the saw when it lies
on a firm surface - never in the hand!
Note: If the engine is restarted just after it has been
stopped - the choke is not needed.
WARNING
www.texas.dk
F7
F8
(3)
F9
(7)
F10
F11
(6)
(5)
29