Table of Contents
Advertisement
Emulation Adapter
2.4
Power-Supply Cable
The power-supply cable (about 300-mm long) supplies power to the emulation adapter.
(1) CN1
Figure 2-6
(1)
Connector: CN1
CN1 is a connector (LEAR-02V-S from JST) for connection to CN2 of the emulation adapter.
(2)
Power jack: J1 (red)
Supply 5 V from a stabilized power supply.
(3)
Power jack: J2 (black)
Connect J2 to GND.
(4)
Tabs for unlocking the connector
When disconnecting the power-supply cable from the emulation adapter, press the tabs on both sides
of the CN1 connector of the power-supply cable to unlock the connector.
Unlocking the connector:
R20UT4569EJ0110 Rev. 1.10
Sep.15.23
(4) Tabs for unlocking the
connector
Names of the Parts of the Power-Supply Cable
Do not press the tabs for unlocking the connector too hard as this may lead to them
being stuck in this position. Take care on this point.
Names and Functions of Hardware
(3) J2
(2) J1
CAUTION
Page 17 of 58
Advertisement
Table of Contents
