Epson ActionNote 910C User Manual page 45

The top edge of the keyboard should not
overlap the bronze-colored ledge of the
case. If you have difficulty aligning the
keyboard, try the following approach:
hold the top of the keyboard in the center.
With the keyboard at a 45° angle, line up
the clips on the bottom of the keyboard
with the case. Gently lift up the keyboard
until the clips are aligned.
4. Position the plastic strip above the
keyboard then push it back until it snaps
into place. The strip fits tightly but should
not obstruct the function keys.
5. Slide the plastic caps over the screws on
each side of the case and snap them into
position Make sure you use the correct
cap for the left or right side; they do not
slide into place on the wrong side.
After you have replaced the keyboard, check
that the keys operate smoothly. If any of the
keys stick, press back again on the plastic strip
under each hinge cover and in the center of
the plastic strip. If the keys still stick, repeat
the keyboard replacement procedure.
5-10 Upgrading Internal Components