Installation/Removal Sequence - Epson Progression User Manual

You can install either one full-height or two half-height hard
disk drives in the internal drive bay.
If you are installing a hard disk, it is best to install it in the
internal bay. This reserves the external bay for any devices that
need to be accessible from the outside, such as a diskette drive
or tape drive. If you prefer, however, you can install a hard disk
in the external bay.

Installation/Removal Sequence

before you begin, check the table below to make sure you
perform all the necessary steps in the proper sequence.
Installation/removal
If you are . . .
Installing a hard disk drive or
removing one and leaving another
in the computer
Removing your only hard disk drive
Installing a diskette drive or other
device
Removing a diskette drive or other
device
Information in each of these sections guides you to the
instructions you should follow next.
When you finish installing or removing your drive(s), see
"Post-installation Procedures" at the end of this chapter for
additional steps you may need to perform.
guide
Begin with this section . . .
'Checking the IDE Hard Disk Drive
Jumpers' on page 4-4
'Removing a Hard Disk Drive From
the Internal Bay' on page 4-25
'Installing a Drive In the External
Bay' on page 4-6
'Removing a Drive From the
External Bay' or page 4-14.
Installing and Removing Drives 4-3