Epson Progression User Manual page 118

3. Grasp the front of the drive and pull it out of the bay.
Note
If you removed an IDE hard disk drive from the external
bay and it is your only hard disk drive, you must also
remove the hard disk drive cable from its connector on
the main system board. First remove the cable from the
clasps on the side of the subassembly. Then disconnect
the cable from the main system board and remove it
from the computer. (See the illustration on page 4-21 to
locate the main system board connector.)
4. If you removed a hard disk drive, go to step 5.
If the drive you removed was accessible from the front of
the computer, you need to reinstall the front panel slot
cover. Turn the front panel so you are looking at the inside.
Then press the slot cover into the slot until it clicks into
place between the tabs on both sides of the opening.
tabs
5. Replace the computer's front panel and cover as described
in Chapter 2; then see 'Post-installation Procedures" on
page 4-27 to update your configuration.
slot cover
Installing and Removing Drives 4-15